The Crack Wizard gets asked this question quite often.
The answer is, water can only enter a basement one of three ways. One: Through the wall. Two: Up from the floor. Three: Over the top of the foundation.
Every home’s foundation is different, and some homes experience none of these symptoms, while other homes experience all three simultaneously.
Why is this information important to consumers? Because the source of the moisture should determine the proper repair.
For homeowners with cracks and leaks in the wall, the most permanent and cost-effective repair is to have the crack(s) pressure injected with either an epoxy or urethane resin. If your water is coming up from the floor and/or where the floor and wall meet, what you’re experiencing is hydrostatic pressure. Depending on the frequency and severity of the water problem, a sump-pump and/or sub-slab drain tile system may be the answer. But before committing to such an invasive, disruptive, and expensive repair, you may want to check your drainage and grading first. In many cases, addressing improper water run-off is a logical and effective first step to correcting a hydrostatic pressure water problem. And finally, if water is making its way over the top of the foundation, this is also attributed to exterior factors that could be corrected with proper and regular maintenance.
The Crack Wizard sees basement water problems every day.
And if you’re not sure where to start, contact The Crack Wizard for a free, no-obligation consultation.The Crack Wizard says, “For A Crack In Your Wall, Give The Wizard A Call”.
The Crack Wizard is open 7 days a week, 7am-9pm to assist you with your foundation repair needs. Go to www.thecrackwizard.com, or call Toll Free (888)-CRACKWIZARD.